Vacuum annealed tin sulfide (SnS) thin films for solar cell applications

Title

Vacuum annealed tin sulfide (SnS) thin films for solar cell applications

Creator

Hegde S.S.; Kunjomana A.G.; Murahari P.; Prasad B.K.; Ramesh K.

Description

Thin films of tin sulfide (SnS) were grown on a glass substrate at an optimum temperature of 300 C by thermal evaporation technique. Following the deposition, films were vacuum annealed at different temperatures in the range of 100 to 300 C for 2 h. The effect of annealing temperature (Ta) on the composition, surface morphology, microstructure, optical and electrical properties was investigated. Elemental analysis showed sulfur deficiency of annealed films and the Sn to S atomic percent ratio increased from 1.0 to 1.1. XRD analysis confirmed the orthorhombic crystal structure of the films with (111) preferred orientation and phase purity. Degree of preferred orientation decreased with increase in Ta and the diffraction peaks corresponding to other planes intensified. Increasing the Ta to 300 C led to an increase in crystallite size to 129 nm. Results indicated presence of several crystallites in the grains of as-deposited films. AFM studies revealed the fragmentation of larger grain and the average grain size reduced form 265 nm for as-deposited films to 132.8 nm for the film annealed at 300 C. An apparent shift in absorption edge towards longer wavelengths is observed for films annealed at Ta > 200 C. The optical constant such as optical band gap, extinction coefficient (k), absorption coefficient (?) and refractive index (n) have been evaluated. The optical band gap of SnS thin films varied marginally with the annealing temperature and remained in between 1.331.29 eV. The extinction coefficient of the film annealed at 300 C was enhanced and is found to be 0.85 at 700 nm. At the annealing temperature of 300 C, the SnS films had enhanced electrical properties: the electrical resistivity was 7.8 ? cm, the p-type carrier concentration was up to 2.17 1016 cm?3, and the mobility was about 36.9 cm2V?1s?1. The variation of physical parameters with Ta has been explained by taking into account the crystallite size and the presented values are discussed with relevance to solar cells. 2017 Elsevier B.V.

Source

Surfaces and Interfaces, Vol-10, pp. 78-84.

Date

2018-01-01

Publisher

Elsevier B.V.

Subject

Absorption coefficient; AFM; Annealing; Thermal evaporation; Thin films; Tin sulfide

Coverage

Hegde S.S., Department of Physics, CMR Institute of Technology, Bangalore, 560037, India; Kunjomana A.G., Department of Physics, Christ University, Bangalore, 560029, India; Murahari P., Department of Physics, Indian Institute of Science, Bangalore, 560012, India, School of Physics and Astronomy, Queen Mary University of London, Mile End, London, E1 4NS, United Kingdom; Prasad B.K., Department of Physics, CMR Institute of Technology, Bangalore, 560037, India; Ramesh K., Department of Physics, Indian Institute of Science, Bangalore, 560012, India

Rights

Restricted Access

Relation

ISSN: 24680230

Format

Online

Language

English

Type

Article

Identifier

https://doi.org/10.1016/j.surfin.2017.12.003

https://www.scopus.com/inward/record.uri?eid=2-s2.0-85038255000&doi=10.1016%2fj.surfin.2017.12.003&partnerID=40&md5=8d2e411d3668cff264b57389bdb55d02